OK, here is how you get this fuse off and replaced

1. This is the fuse box im talking about.


2. Take out the blots with the green circles around them.


3. After you do the the fuse box will come loose and you can pull itoff but be careful because there are still wires attached inside of thebox.


4. Oh yeah here is the 100 amp alt, fuse that i blew. Now the reason idid not just change this fuse it because this fuse dose not just pullout like the rest. It is a pain and is bolted to the inside of thesmaller box of the whole fuse box, sorry i don't have a pic of that ihope it makes since.


5. Now you want to take the bottom of the fuse box off. There is a clipon both sides of the box the you hold down and pull and the bottom willslip off.


6. This is the inside.


7. Now there is a box that sides out of the whole fuse box, a smallerone that hold the 100 amp alt. fuse and a few others. The first greencircle is that box. I suggest you leave it in there because it is apain in the arse to take out. NO JOKE. Next you want to unplug eachwire harness but make sure to remember where each one goes. Now anotherproblem that may confuse people with this is that if you dont want totake the smaller box out you are going to have to figure out how torewire it, i ended up taking my box out and slid it into the new oneafter i connect the rest of the wires.

Now another problem that may confuse people with this is that if youdont want to take the smaller box out you are going to have to figureout how to rewire it, i ended up taking my box out and slid it into thenew one after i connect the rest of the wires. To get the smaller boxout there are clips on the inside around it. It sides in and out fromthe bottom. Like this ...



8. After you connect everything to the new box then bolt it back on andyour good. I hope this helps clean up some confusion. If you have any?s ask me.