I tested this on the gas cap door first just to make sure it wouldn't damage my paint. It's a lot cheaper to get that small door painted versus having a whole panel painted. It didn't damage my finish at all....I didn't have to polish either.

Parts/Supplies Needed:

  • Masking tape or painters tape
  • One can of Easy-Off oven cleaner (use the yellow can)
  • Paper for masking



1) Use the masking tape and paper and mask off above and below the pin stripe. Work on 2-3 foot sections at a time.



2) Spray on the Easy-Off and let it soak in for about 1-3* minutes. *Warning: The time required will vary, test the gas cap stripes first for about a minute, then wipe off. If you need more reapply. This is strong stuff and damage to the paint is certainly possible.*



3) Take a rag and just wipe it off. You shouldn't even have to rub it off. It should just wipe right off with the foam from the Easy-Off. Then remove the tape and paper and use a wet rag to clean up the area. Water neutralizes the Easy-Off. Make sure you wear gloves. It's EASY.

0 total comments, spanning 0 pages.
Showing 0 to 0
Sign in to make a comment.


Submitted by xxx@******.com

Revision 1
Article submitted on 11 Sep 2010
Last modified on 2 Mar 2011
Viewed 2644 times

Please enable / Bitte aktiviere JavaScript!
Veuillez activer / Por favor activa el Javascript![ ? ]