Remove the tweeter cover then pop off the caps and remove the two screws and the 10MM bolt





Carefully pop of this Cap from the top as shown in the picture, remove the screw, and remove the plate.



Remove the two screws.



Remove the System 10 plate and remove the screw.
Remove the screw just under the handle too.



Remove the Door Ajar Light and remove the screw behind it.
To get the lense unit out, use a flat tip screw driver and pry it out from the side of the door.



Now on the side of the door, remove these two screws.



Lastly, remove these two screws.



Now using your hand, wedge it between the panel and the door frame like the pictures shown and give it a quick pull to unsnap the plastic trim pieces.
Or use a trim removal tool and look for the 3 plastic clips you need to remove (see the very last picture for the locations)



Once the bottom becomes loose, the top should still be stuck and how it comes out is it comes "up" so just pull the trim upwards to remove it.
You may or may not need to remove the Tweeter Cover   Once its been unhooked, unplug the power controls.

Remove the Door Panel on a System 10

Submitted by noah_tas@******.com

Revision 1
Article submitted on 4 Dec 2010
Last modified on 10 Oct 2011
Viewed 7453 times