DIY Guides
Manuals
Articles|
A DIY FOR CHANGING YOUR LED IN YOUR MASTER WINDOW SWITCH I have lately started playing with LEDs. So I got bored and decided tochange this LED and make a writeup too. Also because you need to signup for celicatech to see the writeup plus its for a 5th gen soo.... =S,Well enjoy and I hope it helps! TOOLS & PARTS LIST - phillips screwdriver - flat head screwdriver - *working* solder pen - rosin core solder - 3mm LED (color of your choice) - needle nose pliers REMOVAL 1. remove master window switch panel with the help of a flat head screwdriver, pry the part facing towards the end of the car first  2. unscrew the three screws in picture 1  3. carefully pry up on these tabs, there is one on each side to remove the switch from the panel  4. remove these five screws and than flip over to remove the nob  5. lift the tab and than pry up to remove locking window nob from the assembly, carefully pull apart to get to the circuit board  6.lift tabs, there is one on each side. remember to do it carefully todetach the circuit board cover from the remaining assembly  7.voila! there is the LED. the white plastic that the LED is sittingbeside is removal (bend the new LED according to these lengths)  8. to remove old LED solder these joints off, they are tricky to get to. use a good solder pen!  9. I couldn't solder the damn thing off so I instead cut the old LED legs and solder the new LED to cut legs (see picture 8) INSTALLATION  10. install the master window switch and look at your nicely done work! CONGRATULATIONS! YOU JUST CHANGED YOUR LED IN YOUR MASTER WINDOW SWITCH Submitted by xxx@******.com Revision 0 Article submitted on 9 Apr 2010 Last modified on 9 Apr 2010 Viewed 4195 times |
|
|
||||